Please enter some search terms and try again.

NF533D4-1900 Bay Trail - 3.5" Embedded Intel® Bay Trail

Product image
Datasheet

Product Detail

- Intel Celeron J1900 SoC Processor
- Embedded Long-life Series, Planned Lifecycle Through Q1’2019
- 4 * Intel Gigabit LAN Ports
- Built-in +12V Locking Power Jack
- Onboard 4GB DDR3L-1333
- ECO-design for EuP/ErP

See also: Industrial Motherboards and their key features​

Specification

Jetway NF533 3.5" SBC Motherboard
Processor Intel® Celeron J1900, 2.0GHz Quad-Core SoC, 10W, Bay Trail
Memory Onboard 4GB DDR3L-1333 (non-expandable)
Graphics Intel HD Graphics
Audio NA
LAN 4 x Intel I211-AT Gigabit LAN
Storage 1 x SATA2 3Gb/s Connector
1 x Shared mSATA/mini-PCI Express Combo slot (Full-size)
Super IO FINTEK F81768D
Back Panel Connectors
1 Serial Port (RS232)
4 RJ45 LAN (10/100/1000)
1 USB 3.0
1 USB 2.0
1 +12V 2.5MM Diameter Locking DC Power Jack
Onboard I/O Connectors
1 SATA2 3Gb/s Connector
1 Shared mSATA/mini-PCI Express Combo slot (full-size)
2 Mini-PCI Express slot (full-size)
1 Serial port headers (RS232, 2.0 mm pitch)
1 USB Pin Header for up to 2 additional USB 2.0 Ports (2.0 mm pitch)
1 VGA Header (2560X1600 @ 60Hz )
1 SIM Card Socket
1 8 bit GPIO Header
1 AT/ATX Mode jumper
1 PS/2 Mouse/Keyboard header
1 Chassis Intrusion header
2 2-pin LAN LED header
1 4-pin SMBUS header
1 Front Reset/Power buttons
1 4-pin Fan Header
1 4-pin SATA Power Output (Male)
1 2-pin +12V Alternate Power Connector (Molex 5566-2)
Power Supply for NF533
External Power Supply – the board can be powered with a +12V external power supply though a locking DC connector on the back panel. The rear +12V DC jack accepts locking plugs with an inner diameter (ID) of 2.5 mm and an outer diameter (OD) of 5.5 mm, where the inner contact is +12V and the shell is GND.

Internal Power Supply – the board can alternatively be powered via the internal +12V DC 1 x 2 power connector, where pin 1 is GND and pin 2 is +12 VDC.

Caution: There is no isolation circuitry between the external +12V DC jack and the internal 1 x 2 power connector. It is the system integrator's responsibility to ensure no more than one power supply unit is or can be attached to the board at any time and to ensure the external +12V DC jack is covered if the internal 1 x 2 power connector is to be used.


Please contact us for volume pricing.


We like to make life easier, for further help and assistance with this product click to our FAQ's page.

Want more help to find a solution? Contact us or check out our design capabilities.