Jetway 3.5″ Embedded Intel Bay Trail – NF533D4-1900


NF533D4-1900 – Jetway – 3.5″ Embedded Intel Bay Trail – 3.5 SBC – Celeron – Bay Trail – J1900 – 2Ghz – Quad Core – 4Gb – 1333Mhz DDR4 – SATA mSATA Mini PCIe – VGA


Product Detail

– Intel Celeron J1900 SoC Processor
– Embedded Long-life Series, Planned Lifecycle Through Q1’2019
– 4 * Intel Gigabit LAN Ports
– Built-in +12V Locking Power Jack
– Onboard 4GB DDR3L-1333
– ECO-design for EuP/ErP

See also: Industrial Motherboards and their key features​


Jetway NF533 3.5″ SBC Motherboard
ProcessorIntel Celeron J1900, 2.0GHz Quad-Core SoC, 10W, Bay Trail
MemoryOnboard 4GB DDR3L-1333 (non-expandable)
GraphicsIntel HD Graphics
LAN4 x Intel I211-AT Gigabit LAN
Storage1 x SATA2 3Gb/s Connector
1 x Shared mSATA/mini-PCI Express Combo slot (Full-size)
Super IOFINTEK F81768D
Back Panel Connectors
1 Serial Port (RS232)
4 RJ45 LAN (10/100/1000)
1 USB 3.0
1 USB 2.0
1 +12V 2.5MM Diameter Locking DC Power Jack
back panel connectors Bay Trail
Onboard I/O Connectors
1 SATA2 3Gb/s Connector
1 Shared mSATA/mini-PCI Express Combo slot (full-size)
2 Mini-PCI Express slot (full-size)
1 Serial port headers (RS232, 2.0 mm pitch)
1 USB Pin Header for up to 2 additional USB 2.0 Ports (2.0 mm pitch)
1 VGA Header (2560X1600 @ 60Hz )
1 SIM Card Socket
1 8 bit GPIO Header
1 AT/ATX Mode jumper
1 PS/2 Mouse/Keyboard header
1 Chassis Intrusion header
2 2-pin LAN LED header
1 4-pin SMBUS header
1 Front Reset/Power buttons
1 4-pin Fan Header
1 4-pin SATA Power Output (Male)
1 2-pin +12V Alternate Power Connector (Molex 5566-2)
Power Supply for NF533
External Power Supply – the board can be powered with a +12V external power supply though a locking DC connector on the back panel. The rear +12V DC jack accepts locking plugs with an inner diameter (ID) of 2.5 mm and an outer diameter (OD) of 5.5 mm, where the inner contact is +12V and the shell is GND.

Internal Power Supply – the board can alternatively be powered via the internal +12V DC 1 x 2 power connector, where pin 1 is GND and pin 2 is +12 VDC.

Caution: There is no isolation circuitry between the external +12V DC jack and the internal 1 x 2 power connector. It is the system integrator’s responsibility to ensure no more than one power supply unit is or can be attached to the board at any time and to ensure the external +12V DC jack is covered if the internal 1 x 2 power connector is to be used.